Found it in a quick guide: "When configuring a home VDP system, all devices should first be connected together. Usually, this is done by connecting both the camera unit (VTO) and monitor unit (VTH) to the VTNS1060A PoE switch. The VTNS1060A is a 24v passive PoE unit, this is a different type of PoE than that seen on conventional IP devices. Answer: There are 2 ways of doing so: Use a computer and hard wire that to the same network the NVR/DVR is connected to * (NOTE: disable WiFi and/or any VPN or SonicWall from the computer) Download the latest version of SADP from us.hikvision.com. Open SADP, check mark the NVR/DVR, and follow the UNBIND process at the top. Display Interface 1 HDMI ,1 VGA Resolution 1920×1080, 1280×1024, 1280×720 Multi-screen Display When IP extension mode not enabled: 4CH: 1/4 8CH: 1/4/8/9 When IP extension mode enabled: 4CH: 1/4/6 8CH: 1/4/8/9/16 OSD Camera title, Time, Video loss, Camera lock, Motion detection, Recording Network Interface 1 RJ-45 Port (100M) Network Function NVR (Network Video Recorder) usually cannot ‘detect’ IP cameras because it does not possess the same basic functions as an IP camera. An NVR functions as a recorder, storing the video and audio recordings from the cameras that are connected to it. It does not have the same capability of ‘detecting’ an IP camera – which is done by the .

dahua dvr not displaying